January 16, 2019 online meeting minutes

From CLONWiki
Revision as of 07:41, 16 January 2019 by Boiarino (talk | contribs) (Created page with "present: Sergey Boyarinov 1. Run preparations: 1. TS scalers readout chnage - Sergey/Nathan: DiagGuiServer reports lifetime and scalers as activemq messages, it is the only...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

present: Sergey Boyarinov

1. Run preparations: 

1. TS scalers readout chnage - Sergey/Nathan: DiagGuiServer reports lifetime and scalers as activemq messages, it is the only place

2. add 16-channel scope to FADC - Ben: was implemented by previous meeting, ...

3. add normalized scaler with total charge to FADC250 - Ben: was implemented by previous meeting, ...

4. plug RF to right place - Sergey: done



5. Make sure new HTCC trigger is ready - Rafo, Sergey, Ben: ...

6. Trigger dictionary for inbending: ...



7. Level 3 with helicity correction - Sergey: in progress, coda_l3 is fully implemented, in particular it can be added to configuration using codaedit, started in runcontrol as any other component; helicity delay reporting correction in progress



8. New TDs to be installed - Sergey: 2 installed so far, will be done shortly

9. Test setup and spares in counting room - Sergey: ready 

10. Check spare pool again, clean up old boards - Sergey, Nathan (RF splitter for example): in progress

11. Install separate crate for v288's (classchv1): done

12. BAND need 8 DCS2's and Chris will give them remaining FADCs: all boards installed in both crates: 16 FADCs, 16 DCS2s, 2 v1190 TDCs, all firmwares up to date, coda configuration fixed, ready to go



2.

Retrieved from "https://clonwiki0.jlab.org/wiki/index.php?title=January_16,_2019_online_meeting_minutes&oldid=7376"