JLAB TS2

Manual for old TS in (ps)

Manual for old TS in (pdf)

Manual for new TS2 in (doc)

Manual for new TS2 in (pdf)

Branches testing procedure

1. On VME ROC, run vme_link:

• Enter (16-bit hex) interface address ('0' to quit) - 0ed0

2. On SFI ROC, run sfi_link

3. On TS2, run ts2_link:

• Enable FAST L1 mode? (1 = yes, 0 = no) - 0
• Enter ROC buffer mode (1 = buffer, 0 = lock) - 0
• Enter (hex) ROC enable pattern ('0' to quit) - xxxxxxx (roc_mask)
• type 'g' and <enter>

4. When done, type 'q' and <enter> on both

NOTE: group of crates can be tested together, in that case vme_link/sfi_link must be started on each of them, and roc_mask for ts2_link must be set accordingly