January 8, 2014 online meeting minutes: Difference between revisions

Latest revision as of 11:46, 8 January 2014

present: Sergey Boyarinov, Ben Raydo, Hovanes, Chris Cuevas

1. HPS preparations

Ben presented slides about HPS trigger status {pdf}; CTP replaced with GTP, should be no problems; have 2 GTPs, will test in February and see if HallD GTPs can be used as spare (twice smaller FPGA), then decide on building another one or not; muon system will participate in trigger in SSP, matching muon cluster and ECAL cluster, will need another GTP; GTP-SSP connection will be 5GBps with 2 lines, 14 FADCs per crate will be better (7 on each side from switch slots); CLAS12 will do 4x2.5 on new GTP;

FADC HallD firmware will be used as a starting point for Ben's HPS implementation; if not ready, will discuss it again in 1 month; event-by-event pedestal ???

for verification simulated data and FADC playback mode will be used - probably a lot of work here

FADC trigger reports every 32ns with 13bit for energy and 4ns timing resolution; integration in readout and trigger will be similar with the same pedestal to make it easy to compare trigger and readout data for verification purposes; gain matching for trigger will provide energy in MeVs; energy spectra histogram (per channel) may be provided

FADC and SSP trigger info will be readout over VME bus; GTP will have Linux core aka NIOS processor and separate coda_roc there

will start DAQ assembling in the Hall in Ferbuary, probably using FC electronics, sector1 for example

@@ Line 3: / Line 3: @@
 . HPS preparations
- * Ben presented slides about HPS trigger status {pdf}; CTP replaced with GTP, should be no problems; have 2 GTPs, will test in February and see if HallD GTPs can be used as spare  (twice smaller FPGA), then decide on building another one or not; muon system will participate in trigger in SSP, matching muon cluster and ECAL cluster, will need another GTP; GTP-SSP connection will be 5GBps with 2 lines, 14 FADCs per crate will be better (7 on each side from switch slots); CLAS12 will do 4x2.5 on new GTP;
+* Ben presented slides about HPS trigger status {pdf}; CTP replaced with GTP, should be no problems; have 2 GTPs, will test in February and see if HallD GTPs can be used as spare  (twice smaller FPGA), then decide on building another one or not; muon system will participate in trigger in SSP, matching muon cluster and ECAL cluster, will need another GTP; GTP-SSP connection will be 5GBps with 2 lines, 14 FADCs per crate will be better (7 on each side from switch slots); CLAS12 will do 4x2.5 on new GTP;
 * FADC HallD firmware will be used as a starting point for Ben's HPS implementation; if not ready, will discuss it again in 1 month; event-by-event pedestal ???